brand new oil, dramatically extending the life of the oil while removing tramp oil. Hydraulic systems in the Die Cast Industry that use fire resistant water glycol hydraulic oils can... use our nickel plated or anodized units that will not corrode with use. These units would be installed with a shut off valve and pressure compensated flow control valve bleeding.../11 or better Flow Rate .65 GPM 1.20 GPM Min/Max Pressure at Flow Control Valve 100/5000 PSI 100/5000 PSI Inlet Diameter SAE-4 (7/16-20) O-Ring SAE-6 (9/16-18) O-Ring Outlet Diameter...

line, bleeding off a small amount of oil and returning back to the system reservoir. This type of installation is ideal for mobile or light industrial equipment where there would... 0.1 micron Flow Rate .30 GPM .30 GPM .50 GPM .65 GPM 1.20 GPM Min/Max Pressure at Flow Control Valve 100/5,000 PSI 100/5,000 PSI 100/5,000 PSI 100/5,000 PSI 100/5,000 PSI Housing...

code of 18/16/11. Industry guidelines and valve manufacturers advise that an ISO code higher than 16/14/11 contains too many contaminants which cause excessive wear on components...% by volume. How clean does my oil have to be to meet recommended guidelines? The SPI (Society of the Plastics Industry) recommends an ISO code of 16/14/11 or better to be maintained... it take to clean the oil? Depending on how much contamination a hydraulic system has the Filtroil system will filter at the preset flow rate on our pressure compensated flow control...